Tools Required; Materials Required; Hardware Supplied; Hardware Recommendations - Monogram ZIRS36N LH Installation Instructions Manual

Tools • Tinsnips to cut banding
Required
• Stepladder
• Bucket
• Level
• 1-1/4" open-end wrench
Materials
• 2x4, 35" long, for Anti-Tip support, see page 10
Required
• Stick-on hook and loop fastener strips for 1/4" side panels
• 1/4-1/4 union with nuts
Hardware
Supplied
• Anti-tip mounting brackets
Hardware
• Water shut-off valve
Recommendations
• Water filter WR97X0214

Flooring

For proper installation, the refrigerator and freezer must
be placed on a level surface of hard material that is at
the same height as the rest of the flooring. This surface
should be strong enough to support a fully loaded
product.
Step 1
Remove
Packaging
• Remove outer carton.
• Slide out back corner posts (2).
• Slide carton off top of cabinet.
• Remove styrofoam pads taped to base cabinet.
NOTE: IT IS NOT NECESSARY TO LAY CABINET DOWN
IN ORDER TO REMOVE SKID!
• The unit is secured to the skid with 3 slotted tie-down
• Protect the flooring. Cut a large piece of the cardboard
• Support blocks on the bottom must be removed before
• Carefully slide product off skid.
8
CAUTION
Refrigerator is much heavier at the top than at the
bottom – be careful when moving. When using a
hand truck, handle from side only.
PRUDENCE
Le réfrigérateur est beaucoup plus lourd en haut
qu'en bas. Il faut être prudent lors des
déplacements. Si un diable est utilisé, il faut
soulever le réfrigérateur sur le côté seulement.
– Carefully cut banding at the top and bottom.
straps. First remove the 5/16" bolts from the base
channels in the tie-downs, then remove the 7/16" bolts
securing the straps to the skid.
carton and place under the product where you are
working.
sliding unit off skid. Remove support blocks by carefully
tilting cabinet to side and sliding out.
Installation Preparation
36" Stainless Steel Refrigerators, Freezers
• Appliance hand truck
• Tubing cutter
• 7/16" open-end wrench
• #2 Phillips screwdriver
• Stubby Phillips screwdriver
• Copper waterline tubing
• Water shut-off valve (optional but recommended)
• Screws to secure refrigerator to cabinetry
Note: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under the
product where you are working.
DO NOT ATTEMPT TO ROLL UNIT OFF SKID.
IL NE FAUT PAS ESSAYER DE FAIRE ROULER LE
RÉFRIGÉRATEUR POUR L'ENLEVER DE LAY
PALETTE.
• Drill and appropriate bits
• 7/16" socket with 3" extension for
ratchet
• Safety glasses
CAUTION
PRUDENCE
7/16" Bolt