Accessories - KitchenAid ARCHITECT KFGR271SSS Installation Instructions And Use And Care Manual

• Cleaning should always be followed by rinsing with clean warm
water.
• Wipe the surface completely dry with a soft cloth.
• For tough spots or baked-on grease, use Whirlpool Degreaser
(Part No. 31552), a commercial degreaser designed for stainless
steel. See "Requesting Assistance or Service" section to order.
Interior
Discoloration of stainless steel on these parts is to be expected,
due to intense heat from the burners.
• Cleaning should always be followed by rinsing with clean, warm
water.
• Use a mild liquid detergent or all-purpose cleaner, following label
instructions. Rinse with clean water and dry completely with a
soft, lint-free cloth.
• A heavy-duty scrub sponge can be used with mild cleaning
products. Always rub in the direction of the grain.
• For small, diffi cult-to-clean areas, use Whirlpool Degreaser (Part
No. 31552), a commercial degreaser designed for stainless steel.
See "Requesting Assistance or Service" section to order.
Side burner caps and grate
• Clean with a brass bristle brush.
• Wash grate using mild detergent, warm water and degreaser.
• Rinse with clean water and dry with soft, lint-free cloth.
• Use Stainless Steel Cleaner & Polish (Part No. 4396095). See
"Requesting Assistance or Service" section to order.
U-shaped burners
* Clean the exterior of the burner with a wire brush.
* Clear any clogged burner ports with a straightened paper clip.
Never use a toothpick as it may break off and clog the port.
* Use a fl ashlight to inspect into the burner through the burner
inlet to ensure there is no blockage. If any obstruction is seen,
use a metal coat hanger that has been straightened to clear
them.
After inspecting the inside of burner for blockage, reassemble
burner by sliding the middle tube of burner over orifi ce. Insert tabs
on the burner bracket into the holes in burner support.
burner bracket
holes
burner support
Drip tray
IMPORTANT: The drip tray should only be removed when grill is
completely cool.
22
tab
orifi ce
The full-width drip tray collects grease and food particles that fall
through the grill. Remove tray and set on a fl at surface.
• Wipe excess grease with paper towels.
• Use mild detergent, warm water. Rinse and dry thoroughly.
Replace tray.
• Clean often to avoid grease build-up.
Knobs, plastic and fl ange area around knobs
IMPORTANT: Do not use steel wool, abrasive cleaners, or oven
cleaner.
Do not soak knobs.
• Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
Control panel graphics
IMPORTANT: Do not use steel wool, abrasive cleaners or oven
cleaner.
Do not spray cleaner directly onto panel.
Clean around the burner labels gently; scrubbing may remove
printing.
• Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
Rotisserie spit rod handle
(On some models)
• Do not use steel wool, abrasive cleaners or oven cleaner.
• Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
Rotisserie spit rod and forks
(On some models)
• Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
• For stubborn areas, use a multi-purpose cleaner, a heavy-duty
scrub sponge or mild abrasive cleaner.

Accessories

Custom Access Door Kits are available from your dealer.
27" (68.6 cm): Door Kit No. KBAD271SSS
30" (76.2 cm): Door Kit No. KBAD301SSS
36" (91.4 cm): Door Kit No. KBAD361SSS
Vinyl Grill Covers are available from your dealer.
Built-in models:
27" (68.6 cm): Cover No. 4396323
36" (91.4 cm): Cover No. 4396325
Portable models:
27" (68.6 cm): Cover No. 4396324
36" (91.4 cm): Cover No. 4396326
48" (121.9 cm) [36" (91.4 cm) grill with side burner]:
Cover No. 4396634
Rotisserie kits for portable (freestanding) grills are available from
your dealer.
27" Rotisserie Kit No. KFRK271SSS
36" Rotisserie Kit No. KFRK361SSS