Using The Side Burner; Using The Rotisserie - KitchenAid ARCHITECT KFGR271SSS Installation Instructions And Use And Care Manual

Using the Side Burner

WARNING
Burn Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Doing so can result in burns.
Remove the side burner cover. Do not light burners with the cover
on.
Lighting the side burner
1. Do not lean over the grill.
2. Push in the side burner control knob. Turn the knob to "LITE/HI"
and hold in.
3. You will hear the "snapping" sound of the spark. When burner is
lit, release the knob. Turn knob to desired setting.
Repeat for each of the other burners as needed.
IMPORTANT:
If burner does not light immediately, turn the burner knob to "OFF"
and wait 5 minutes before relighting.
Manually lighting the side burner
1. Do not lean over the grill.
2. Remove the manual lighting extension from inside the drip tray.
3. Attach a match to the clip.
4. Strike the match to light it.
5. Guide the match to the burner you wish to light.
6. Push in and turn the burner knob to "LITE/HI" for the burner
closest to the lit match. The burner will light immediately. When
burner is lit, turn knob to desired setting
7. Repeat steps 3 through 6 for each burner.
8. Remove match and replace manual lighting extension inside
the drip tray.
IMPORTANT:
If burner does not light immediately, turn the burner knob to "OFF"
and wait 5 minutes before relighting.
If any burners do not light after attempting to manually light them,
contact the KitchenAid Customer Experience Center.

Using the Rotisserie

rotisserie
fork
motor
IMPORTANT: On Model KFGR383SSS
remove the handle from the spit rod
when using the side burner.
The handle will get "HOT" and failure to
remove it will cause the handle to crack
and melt.
For best cooking results, do not use main grill burners when using
the rotisserie.
The rotisserie system is designed to cook food from the rear using
intense, searing infrared heat.
1. Remove warming shelf.
2. Mount rotisserie motor on the grill's mounting bracket. Position it
securely into support bracket slots.
3. To load the spit rod, slide one of the rotisserie forks onto the spit
rod with prongs facing away from handle.
4. Push spit rod through the center of the food, then slide second
rotisserie fork into position.
5. Center the food and rotisserie forks on spit rod and tighten wing
nuts on the rotisserie forks. If necessary, secure loose food
portions with butcher's string only.
6. Once the food is positioned on spit rod, place pointed end of
rod into rotisserie motor and lower spit rod onto supports at
either side of the grill.
7. Plug single-prong plug into rotisserie motor.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
8. Plug three-prong rotisserie plug into a grounded three prong
outlet.
rotisserie burner
spit rod
remove
handle
15