Using The Rotisserie - KitchenAid Architect KBGS274SSS0 Installation Instructions And Use And Care Manual

Using the Rotisserie

rotisserie
fork
motor
For best cooking results, do not use main grill burners when using
the rotisserie.
The rotisserie system is designed to cook food from the rear using
intense, searing infrared heat.
1. Remove warming shelf.
2. Mount rotisserie motor on the grill's mounting bracket. Position it
securely into support bracket slots.
3. To load the spit rod, slide one of the rotisserie forks onto the spit
rod with prongs facing away from handle.
4. Push spit rod through the center of the food, then slide second
rotisserie fork into position.
5. Center the food and rotisserie forks on spit rod and tighten wing
nuts on the rotisserie forks. If necessary, secure loose food
portions with butcher's string only.
6. Once the food is positioned on spit rod, place pointed end of
rod into rotisserie motor and lower spit rod onto supports at
either side of the grill.
7. Plug single-prong plug into rotisserie motor.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
8. Plug three-prong rotisserie plug into a grounded three prong
outlet.
12
rotisserie burner
spit rod
To avoid product damage when not using the rotisserie, remove
motor and store indoors. Remove spit rod and forks. Store out of
reach of children.
Lighting the rotisserie burner
1. Do not lean over the grill.
2. Push in the rotisserie burner knob and turn the knob to
"LITE/HI". You will hear the "snapping" sound of the spark.
3. When the rotisserie burner lights, continue to hold the knob in
for another 10 seconds, then release the knob and burner will
stay lit. You will hear the "snapping" sound of the spark until the
knob is released.
IMPORTANT: If the rotisserie burner does not light immediately,
turn the burner knob to "OFF", wait 5 minutes before relighting.
Manually lighting rotisserie burner
1. Do not lean over the grill.
2. Remove the manual lighting extension from inside the drip tray.
3. Attach a match to the clip.
4. Strike the match to light it.
5. Gently hold the lit match close to the rotisserie burner.
6. Push in and turn the rotisserie burner control knob to "LITE/HI".
Hold this knob in for 10 seconds after the burner is lit. You will
hear the "snapping" sound of the spark until after the knob is
released.
IMPORTANT: If the rotisserie burner does not light immediately,
turn the rotisserie burner control knob to "OFF" and wait 5 minutes
before relighting.
7. Remove the match and replace the manual lighting extension
inside the drip tray.
light