Connecting The Modem - Zhone iMarc SLV 9126 Installation Instructions Manual

Connecting the Modem

Procedure
1
Insert the RJ11C connector on the modem cable into the Modem/MDM interface.
2
Insert the other end of the cable into the phone service RJ11C jack.
POWER
3
Verify modem operation.
If Port Use is set to Terminal (dial-in access):
— Dial the modem's phone number using a remote asynchronous terminal or PC.
— Verify that the Main Menu appears.
If Port Use is set to Net Link (SNMP, Telnet, FTP, and trap dial-out):
— Dial the modem's phone number using a PC running PPP or SLIP link protocol.
— From the PC, run an IP Ping test to the modem interface.
If your results using either method are unsuccessful, make sure both ends of the modem
cable are properly seated and secured. Then, verify that the modem was configured
correctly (see Setting Up the Modem
in the iMarc SLV Operations Guide.
Proceed to on Connecting to the ISDN Interface
DBM.
9126-A2-ZN11-40
COM ENET DSX DSX-1 NET MDM DBM
on page 18). Otherwise, refer to the status information
on page 28 if the iMarc unit is equipped with a
RJ11C
Jack
02-17289
27