Table of Contents
Advertisement
12
Set up the modem and the Call Directories if trap dial-out is desired (see
Modem
on page 18).
13
If the unit is equipped with an ISDN DBM, set up the DBM (see
on page 20).
14
If SNMP traps are wanted, set up managers, select the desired traps, and configure trap
dial-out if desired (see
15
Save the configurations.
16
Verify the entire path from the remote unit to the NMS is functioning (see
End-to-End Path
17
If the DSX-1 interface will be used, install the DSX-1 cable (see
Interface
on page 25). Time slots for the DSX-1 interface will need to be assigned to the
network interface (see Assigning DSX-1 Time Slots to the Network Interface in the iMarc
SLV Configuration Reference).
18
Install the DTE cable (see
19
Install the modem cable (see
20
Install the ISDN DBM cable (see
21
If required, connect the Ethernet port to the LAN (see
page 28).
22
Verify that data is being received (see
23
Verify that all PVCs, including Management PVCs, are configured; and see whether
the PVC is active or not (see
24
Verify the setup for backup, if applicable (see
DBMs
on page 30).
The iMarc installation is complete.
14
Configuring SNMP Trap Managers and Trap Dial-Out
on page 24).
Connecting to a DTE (Router or FRAD)
Connecting the Modem
Connecting to the ISDN Interface
Checking PVC Connections
on page 27).
Connecting the Ethernet Port
Verifying That Data is Being Received
on page 29).
Verifying That Data Can Be Passed Between
Setting Up the
Setting Up the ISDN DBM
on page 22).
Verifying the
Connecting to the DSX-1
on page 26).
on page 28).
on page 29).
9126-A2-ZN11-40
on
Advertisement
Table of Contents
