Cmos Status - Acorp 6M810E User Manual

2-2-3 CMOS Status

Please clear CMOS if password is forgotten. Below is the details to clear CMOS.
Procedure to clear CMOS:
Step 1: Shut down the system and disconnect the power supply from AC power.
Step 2: Pull out the power supply cable from the power connector.
Step 3: Short the CMOS jumper by putting jumper cap on Pin 2-3 for a few seconds.
Step 4: Return the cap to pin 1-2 at normal setup.
Step 5: Link the power cable to the connector & connect AC power to power supply.
Step 6: Turn on system power.
If you'd like to set password, press "Del" Key during system boot up to enter CMOS
setup and establish a new password.
6M810E Main Board
CMOS Status
1-2: normal 2-3: clear CMOS
1
2
3
11
1
2
3