Jp12 : Cmos Status - Acorp 6A815EP User Manual

2-2-3 JP12 : CMOS Status

Please clear CMOS if password is forgotten. Below is the detail to clear CMOS.
Procedure to clear CMOS:
Step 1: Shut down the system and disconnect the power supply from AC power.
Step 2: Pull out the power supply cable from the power connector.
Step 3: Short the CMOS jumper by putting jumper cap on Pin 2-3 for a few seconds.
Step 4: Return the cap to pin 1-2 at normal setup.
Step 5: Link the power cable to the connector & connect AC power to power supply.
Step 6: Turn on system power.
If you'd like to set password, press "Del" Key during system boot up to enter
CMOS setup and establish a new password.
INTEL 815EP
JP 12 : CMOS Status
2
3 1
2
3 1
11
Set to "1-2" :
Normal(default)
Set to "2-3" :
Clear CMOS