Reliance electric 1203-USB Instruction Manual page 35

Troubleshooting
Events
Type 0 Time Flt
Use I/O Sent
Press the UP ARROW or DOWN ARROW key to scroll through the
parameter list. Press the LEFT ARROW or RIGHT ARROW key to
modify parameter values. Press the ENTER key to save a new
value.
1> Clr Event Queue = Enable
Figure 5.3 – Example Parameter 03 Display im HyperTerminal
Code Event
F0 No Event
F1 Adapter Reset
F2 Slave Detected
F3 Slave Removed
F4 Host Timeout
F5 Slave Timeout
F6 Master Timeout
F7 Serial Timeout
F8 Control Enabled
F9 Control Disabled
F10 EEPROM Sum Flt
Table 5.7 – For DPI Drives
Description
The converter has not received a type 0 status
message within the specified time.
The converter has begun sending drive-specific
control information.
Table 5.8 – For MDI Drives
No event present in the event queue.
The converter was reset by the user.
A slave was detected to be present by the
master.
A slave was detected to be removed by the
master.
A timeout condition on Msg to Host.
A timeout condition on Msg to Slave.
A timeout condition on Msg to Master.
A timeout on Serial 232 side (with control
enabled).
The converter has sent a "Soft Control
Enable" command to the drive.
The converter has sent a "Soft Control
Disable" command to the drive.
Startup sequence detected corrupt
EEPROM storage in the converter.
Description
5-7