Using The Mdi Class Oim; Using V*S Utilities - Reliance electric 1203-USB Instruction Manual

4.3 Using the MDI Class OIM

4.4 Using V*S Utilities

4-4
If you are connected to a MDI drive, you can use a MDI OIM (Operator Interface
Module) to access and edit parameters in the 1203-USB converter (see basic steps
shown below). It is recommended that you read through the steps for your OIM before
performing the sequence. For additional OIM information, refer to the OIM Quick
Reference card.
Step
1. Power up the drive. Then
plug the OIM into the
drive. The Parameters
menu for the drive will be
displayed.
2. Press the Sel key once to
display the Device Select
menu.
3. Press Enter to display the
MDI Devices menu.
Press Down Arrow to
scroll to 1203-USB.
4. Press Enter to select the
converter. The
Parameters menu for the
converter will be
displayed.
5. Press Enter to access the
parameters. Edit the
adapter parameters using
the same techniques that
you use to edit drive
parameters.
Using V*S Utilities software (version 4.06 or higher), you can edit parameters in both
the 1203-USB converter and the connected drive. With DPI and MDI drives, you can
also edit parameters in any of their attached peripherals V*S Utilities is shipped with
the 1203-USB Converter.
Table 4.4 – Using the OIM
Key(s)
Sel
OR
Example Screens
Parameters
Groups
Linear List
Changed Params
DIAG PARAM DSEL MEM SEL
Device Select
DSI Devices
DIAG PARAM DSEL MEM SEL
MDI Devices
PowerFlex 40
1203-USB
Parameters
Linear List
Changed Params
DIAG PARAM DSEL MEM SEL
Mode
Parameter: #
Auto 0
VALUE LIMITS SEL
USB Converter User Manual
001