S Utilities Quick Start - Reliance electric 1203-USB Instruction Manual

4.5 V*S Utilities Quick Start
Configuring the Converter
Important: For MDI drives, converter Adapter Cfg (01) must be set to "Auto" (default)
for V*S Utilities to operate. If this parameter needs to be changed,
HyperTerminal can be used to configure the converter
Terminal Emulation Software" on page
This section is designed to help you start using V*S Utilities.
1. Obtain and note the COM port that was assigned during installation of the
1203-USB driver. To do this:
a. Open the Windows Control Panel and double-click on System.
b. In the System Properties window, click on the Hardware tab and then
click Device Manager.
c. In the Device Manager menu tree, expand the Port (COM & LPT) group.
The assigned COM port is shown in parenthesis at the end of the
Reliance Electric1203-USB entry.
2. If it is not already running, launch V*S Utilities
3. In the V*S Utilities application window, select Explore > Configure
Communication. Select the COM port noted in Step 1 and a baud rate of
"115200." Select either checksum, and accept the default time for the Comm.
Timeout. Then click OK.
4. Select Explore > Connect > Serial Point-to-Point. A node eventually appears in
the V*S Utilities Parameter List Window
tree.
(Figure
Figure 4.1 – V*S Utilities Parameter List Window
(See "Using
4-6.).
4.1) under Devices in the menu
4-5