Installing The Converter - Reliance electric 1203-USB Instruction Manual

3.2 Installing the Converter

3-2
Item
➊
DPI cable to connect the converter to a
DPI drive.
➋
USB cable to connect the converter to
the computer.
Figure 3.2 – Cables for Connecting to a MDI Drive and Computer
Item
➊
MDI cable to connect the converter to a
MDI drive.
➋
USB cable to connect the converter to
the computer.
Important: The MDI cable shield must be properly grounded to provide EMC
protection. On a MD60 drive, Pin 16 of the drive control terminal block
must be connected to the drive earth ground terminal.
Important: The converter must not be installed in an area where the ambient
atmosphere contains volatile or corrosive gas, vapors or dust. If the
converter is not going to be installed for a period of time, it must be stored
in an area where it will not be exposed to a corrosive atmosphere.
1. Connect the converter to the drive
Table 3.1 – Cable Descriptions (DPI)
Description
➊
Table 3.2 – Cable Description (MDI)
Description
(Figure 3.3) using the appropriate cable
Catalog Number
20-OIM-HIO
➋
Catalog Number
22-OIM-HIO
USB Converter User Manual