RGBlink VSP 112W User Manual page 44

4. Menu Orientation
MENU
BLEND MODE: Blend mode, with two modes, ―Mode 1‖ and ― Mode 2‖.
Mode 1: Graphic content locate at the top and is non-transparent,
background transparency is controlled by double-picture transparency;
Mode 2: Graphic content is controlled by double-picture transparency, the
background is completely transparent;
BLEND LEVEL: Can set the image display transparency, regulating range
between 0 - 16.
ABOVE/BELOW:
ABOVE: In image 2, if the pixel value is higher than the setting value, then
the image is the graphic content pixel, otherwise, it is the graphic
background pixel. It should combined with "AND/OR" conditions when
judging.
BELOW: In image 2, if the pixel value is lower than the setting value, then
the image is the graphic content pixel, otherwise, it is the graphic
background pixel. It should combined with "AND/OR" conditions when
judging.
AND/OR:
AND: All ―Red, Green, Blue‖ value must meet ABOVE or BELOW
conditions.
OR: Any one of ―Red, Green, Blue‖ value should meet ABOVE or BELOW
conditions.
RED: Red limit, cut-off point condition of ABOVE and BELOW condition in
red channel, the range is 0 ~ 255.
GREEN: Green limit, cut-off point condition of ABOVE and BELOW
condition in green channel, the range is 0 ~ 255.
BLUE: Blue limit, cut-off point condition of ABOVE and BELOW condition in
blue channel, the range is 0 ~ 255.
DISPLAY MODE:
MODE: Image mode selection, user can choose different output modes
VSP 112W User Manual 44