Cisco PRP-2 Installation And Configuration Manual page 8

Performance route processor
Table of Contents

Advertisement

Product Overview
1.330GHz dual-core MPC8641D Rev 2.1, 532MHz MPXclk
Discovering memory in slot DIMM1 ......................... Found 2GB DIMM
Discovering memory in slot DIMM2 ......................... Found 2GB DIMM
Pausing between init of DDR1 and DDR2...
Testing low memory ....................................... OK
Loading main ROMMON image ................................ OK
Verifying loaded image ................................... OK
Load succeeded; launching target ......................... OK
eth0 auto-negotiation completed in 1581ms
eth0 link up and operating in 100BASE-TX full-duplex mode
eth1 auto-negotiation completed in 2189ms
eth1 link up and operating in 100BASE-TX full-duplex mode
Cisco ROMMON System Bootstrap, Version 1.0.0 (bld1) DEVELOPMENT SOFTWARE
Compiled on 04/07/08 at 15:18:19 PDT [BLD-rommon]
Copyright (c) 1994-2008 by cisco Systems, Inc.
MPC8641D platform with 4GB of main memory
rommon 1 >
Execute the following steps to boot a Cisco IOS XR software image from ROMMON using TFTP.
Step 1
Configure the IP address of the Ethernet interfaces eth0: and eth1: on the router.
rommon 1 > ifconfig eth0 10.12.6.101 255.255.0.0 up
rommon 2 > ifconfig eth1 10.14.6.102 255.255.0.0 up
Verify that the IP address is configured properly and the ethernet interface link state is UP.
Step 2
rommon 3 > ifconfig
eth0
eth1
Save the changes (IP address configuration) to NVRAM.
Step 3
To save the configuration changes to NVRAM permanently, use the sync command.
Note
rommon 4 > sync
Data successfully written to NVRAM
Step 4
To enable loading of the Cisco IOS XR software image from TFTP server, add the IP address, subnet
mask, and gateway address of the TFTP from which the request is finally sent.
Note
Upon adding the route details of the TFTP server and gateway, a route table is created on ROMMON.
rommon 5 > route add 223.255.254.0 255.255.255.0 10.12.0.1
Route successfully added
Verify that the route table with the specified IP address and gateway of the TFTP has been created on
Step 5
ROMMON.
rommon 6 > route
8
HWaddr: 00:02:17:ea:c3:f1
IPaddr: 10.12.6.101
Netmask: 255.255.0.0
Status: UP
Link: UP
HWaddr: 00:02:17:ea:c3:f0
IPaddr: 10.14.6.102
Netmask: 255.255.0.0
Status: UP
Link: UP
OL-17436-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prp-3

Table of Contents