Cisco PRP-2 Installation And Configuration Manual page 79

Figure 22
1
2
3
4
5
Before proceeding, ensure that you have the proper tools and ESD-prevention equipment available. To
upgrade SDRAM, you will install DIMMs in one or two banks (U15 and U18).
available configurations of SDRAM DIMMs, the number of DIMMs for each configuration, and the
SDRAM banks they occupy. Note which banks you should use, given the combinations of available
DIMM sizes and the maximum SDRAM you require.
Depending on the configuration of your router and the protocols and features your system is running,
Note
you might require more than the default SDRAM provided. Upgrade SDRAM based on your
requirements and the information in
.
OL-17436-01
Locations of PRP Components and Memory
2
4
5
Backplane connector
Flash SIMM (Socket number P3)
SDRAM DIMMs
Bank 1 - Socket number U15
Bank 2 - Socket number U18
Ejector lever
Flash disk slots
Additional Configuration and Maintenance Tasks
1
ETH 0 ETH 1 AUX CONSOLE
PERFORMANCE ROUTE PROCESSOR 1 (PRP-1)
7 8
6
6
Ethernet ports
7 Auxiliary port
8 Console port
9 Handle
10 Display LEDs
Table 27.
3
9 10
Table 27 list the various
79