Removing A Dimm - Cisco PRP-2 Installation And Configuration Manual

Table 28
Total Route Memory
4 GB
8 GB
1. Bank 1 (U15) must be populated first.
Only memory approved by Cisco is supported. Both the DIMMs must be of the same size. Do not attempt
Caution
to install other devices or DIMMs not approved by Cisco in the DIMM sockets. (See
Table

Removing a DIMM

To remove a DIMM from a line card, follow these steps:
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Place the line card on an antistatic mat so that the faceplate is nearest to you.
Step 2
Locate the DIMM sockets on the line card.
Step 3
Note
Figure 24
Figure 25
OL-17436-01
Supported PRP-3 Route Memory Configurations
Cisco Product Number
MEM-PRP3-4G=
MEM-PRP3-8G=
27.)
Some line cards use DIMM sockets equipped with dual release levers, as shown in
other line cards use DIMM sockets equipped with a single release lever, as shown in
Both DIMM sockets operate in the same general way.
DIMM Socket with Dual Release Levers
DIMM Socket with Single Release Lever
Additional Configuration and Maintenance Tasks
DIMM Modules SDRAM DIMM Sockets
2 2-GB DIMMs Bank 1 (U8) and Bank 2 (U10)
2 4-GB DIMMs Bank 1 (U8) and Bank 2 (U10)
1
Table 26 and
Figure 24;
Figure 25.
81