Cisco PRP-2 Installation And Configuration Manual page 71

Removing and Installing a Compact Flash Disk
You must remove the PRP-2 before you can remove or install a compact flash disk. The compact flash
Note
disk is only supported on the PRP-2.
To remove a compact flash disk (CF) from the PRP-2 board, follow these steps:
Loosen the screw fastening the retaining bracket for the CF. (See
Step 1
Lift the end of the retaining bracket out of the hole that holds it in place flush with the CF, and swivel it
Step 2
around until it is not in the way of removing the CF. (See
Press lightly on the CF and push it out of its socket in the direction of the retaining bracket. (See
Step 3
Figure
Figure 19 Removing the CF from the PRP-2 Board
Once the CF is released from the socket, pull it completely out of the board.
Step 4
If you are not inserting another CF into the socket on the board, replace the retaining bracket by
Step 5
swivelling it back around until the end rests in the hole on the PRP-2 board and fastening the screw into
the board.
To install a CF into the PRP-2 board, follow these steps:
Loosen the screw fastening the retaining bracket for the CF.
Step 1
Lift the end of the retaining bracket out of the hole that holds it in place flush with the CF socket, and
Step 2
swivel it around until it is not in the way of installing the CF.
Guide the CF into the socket with the side with the connectors going into the socket.
Step 3
Push the CF until it snaps into place in the socket.
Step 4
OL-17436-01
19.)
Additional Configuration and Maintenance Tasks
Figure 19.)
Figure 19.)
71