Cisco PRP-2 Installation And Configuration Manual page 72

Additional Configuration and Maintenance Tasks
Swivel the retaining bracket back into place with the end of the bracket resting in the hole on the PRP-2
Step 5
board.
Step 6 Fasten the screw on the retaining bracket.
Removing and Installing a Hard Disk Drive
You must remove the PRP-3 or PRP-2 before you can remove or install a hard disk drive. The hard disk
Note
drive is only supported on the PRP-2.
To remove a hard disk drive (HDD) from the PRP-3 or PRP-2 board, follow these steps:
Loosen the four screws fastening the HDD to the board. The screws will pop out of place when they are
Step 1
completely loosened.
Pull the HDD straight up off the board.
Step 2
To install an HDD onto the PRP-3 or PRP-2 board, follow these steps:
Position the HDD over the four screw receptors on the PRP-3 or PRP-2 board so that the two silver guide
Step 1
pins on the board fit into the two associated holes on the HDD (next to two of the screws) and the arrow
printed on the top of the HDD points toward the faceplate of the card. See
72
Figure 20.
OL-17436-01