Cisco PRP-2 Installation And Configuration Manual page 66

Additional Configuration and Maintenance Tasks
Step 7
Step 8
Examples
The following example sets the configuration register so that the router will restart in ROM monitor
mode:
Router# configure
Router(config)# config-register 0x0
Router(config)# commit
Router(config)# no config-register 0x0
Router(config)# commit
Router(config)# end
Router# reload
Changing the Configuration Register Settings from ROM Monitor Mode
When the router is in ROM monitor mode, you can change the configuration register by entering the
value manually, or by allowing the ROM monitor to prompt you for the setting. This section describes
how to manually enter the configuration register setting.
To manually change the configuration register setting in ROM monitor mode, enter the confreg
command followed by the new value.
SUMMARY STEPS
1.
2.
66
Command or Action
end
Example:
Router(config)# end
reload
Example:
Router# reload
confreg value
reset
Purpose
Exits global configuration mode.
Reloads the system for the changes to take effect.
OL-17436-01