Cisco PRP-2 Installation And Configuration Manual page 37

Connect the Ethernet and console cables to the PRP.
Step 13
Remove the Flash disk from slot1: on the GRP and insert the Flash disk into slot0: on the PRP.
Step 14
Boot the router.
Step 15
The router will come up with no configuration and prompt you to enter the Initial Configuration menu.
Step 16
Abort the Initial Configuration options by entering no when prompted.
Copy the configuration file which is stored on disk0: to the startup-configuration on the PRP by using
Step 17
the command copy disk0: config-name startup-config.
Note
Upgrade the Mbus-agent-rom by using the command upgrade mbus-agent-rom all. Line cards do not
Step 18
need to be reloaded. If any error messages are displayed (see following example), repeat this step before
contacting Cisco TAC.
MBus agent ROM upgrade failed on slot 7 (rc=5)
MBus agent ROM upgrade failed on slot 8 (rc=6)
Upgrade the fabric downloader by using the command upgrade fabric-downloader all. The line cards
Step 19
do not need to be reloaded. If any error messages are displayed (see following example), repeat this step
before contacting Cisco TAC.
Fabric-downloader upgrade failed on slot 7 (rc=5)
Fabric-downloader upgrade failed on slot 8 (rc=6)
Make a note of which slot the PRP is installed in the chassis. You can use the show gsr command to view
Step 20
this information. In the following example, the RP is located in slot 3.
Router# show gsr
Slot 0
Slot 3
Slot 17 type
Slot 18 type
Slot 19 type
Slot 20 type
Slot 24 type
Slot 25 type
Slot 28 type
Step 21 Use the command upgrade rom-monitor slot rp-slot.
Step 22 If the routine finds that an upgrade is necessary, the new code will be loaded. The router will reload once
the rom-monitor upgrade has completed, without saving the running configuration.
If the rom-monitor upgrade was not required, you must now reload the router. If you are prompted to
save the system configuration, answer no.
System configuration has been modified. Save? [yes/no]: no
OL-17436-01
Do not copy the configuration file to the running configuration.
type = 3 Port Gigabit Ethernet
state = IOS RUN Line Card Enabled
type = Route Processor
state = ACTV RP IOS Running
= Clock Scheduler Card(6) OC-192
state = Card Powered
= Switch Fabric Card(6) OC-192
state = Card Powered
= Switch Fabric Card(6) OC-192
state = Card Powered
= Switch Fabric Card(6) OC-192
state = Card Powered
= Alarm Module(6)
state = Card Powered
= Alarm Module(6)
state = Card Powered
= Blower Module(6)
state = Card Powered
ACTIVE
PRIMARY CLOCK
Upgrading to the PRP
37