Cisco PRP-2 Installation And Configuration Manual page 69

Figure 17
Figure 18
Installing a Flash Disk
To install a flash disk, follow these steps:
Step 1 Remove the flash disk slot cover by loosening the captive screw shown in
Step 2 Facing the PRP front panel, hold the flash disk with the connector end of the card toward the slot and
the label facing to your right. (See
Note
Insert the card into the appropriate slot until the card completely seats in the connector at the back of the
Step 3
slot and the ejector button pops out toward you.
Replace the flash disk slot cover.
Step 4
OL-17436-01
Installing and Removing a Flash Disk
PRP-3—Installing and Removing an External CompactFlash
The Flash disk is keyed and cannot be seated the wrong way. The ejector button will not pop out
if the card is not properly inserted.
Additional Configuration and Maintenance Tasks
ETH 0 ETH 1 AUX CONSOLE
Figure 17.)
PERFORMANCE ROUTE PROCESSOR 1 (PRP-1)
Figure 16.
69