Cisco PRP-2 Installation And Configuration Manual page 26

Checking the Installation
LED Display
RUN/IOX
RP/ACTV
Table 8
ROMMON.
Table 8
LED Display
INIT/NV
OK/RIO
OK/CPU
CONT...
Dual PRP-3 Scenario
If dual PRP-3s are installed and the chassis is powered on or a board is inserted, all the LED messages
are same as for a single PRP-3, except for an LED message '1404/MRAM' that is displayed on the front
panel when the console display is as follows:
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
26
Description or Console Message
Displays "RP/0/2/CPU0:Sep 10 15:56:29.018: syslogd_helper: [84]:
dsc_event_handler: Got SysMgr dSC
event : 1
RP/0/2/CPU0:Jan 1 00:00:04.809 : mbus-prp3[58]: mbus-prp3:
mbus_platform_init() failed (0x6).
RP/0/2/CPU0:Sep 10 15:56:07.015 : dumper[53]: No HDD Controller found
by process dumper
RP/0/2/CPU0:Sep 10 15:56:21.538 : sysmgr[85]: %OS-SYSMGR-5-NOTICE
: Card is COLD started
RP/0/2/CPU0:Sep 10 15:56:22.622 : dsc[169]: Memory Sanity Check Enabled
RP/0/2/CPU0:Sep 10 15:56:29.007 : dsc[169]:
%PLATFORM-DSC-3-ERR_I_AM_DSC : Setting myself as DSC
RP/0/2/CPU0:Sep 10 15:57:20.071 : sysldr[370]:
%PLATFORM-POWERMGR-3-ROM_ERROR_STATUS :
Unable to get Mbus ROM status from SYSDB. Error ='sysdb' detected the
'warning' condition 'A SysDB client tried to access a nonexistent item or list an
empty directory'
RP/0/2/CPU0:Sep 10 15:57:25.078 : sysldr[370]: %
PLATFORM-SYSLDR-6-INFO : Waiting for startup config to be applied
before booting LCs
Primary Clock is CSC_1 Fabric Clock is Redundant
Bandwidth Mode : Full Bandwidth"
When RP is up and running Cisco IOS XR software.
displays the alphanumeric LED messages and the console output when the chassis is loaded from
Single PRP-3 Scenario — Chassis loaded from ROMMON
Description or Console Message
Displays the LED message during the initialization of the NVRAM infra code.
Displays the LED message immediately when the board is powered ON.
Displays "1.330GHz dual-core MPC8641D Rev 2.1, 532MHz MPXclk".
OL-17436-01