Table of Contents
Advertisement
INSTALLATION MANUAL
Water and Moisture
ple, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool.
Power Cord Protection
NEC standards.
Telephones
—Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of elec-
trical shock from lightning. Do not use a telephone to report a gas leak if the leak is in the vicinity of the ELAN electronic equipment
because of risk of fire or explosion.
Cleaning
—Turn off the circuit breaker to this audio product before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth
for cleaning.
Power Lines
—An outdoor antenna should be located away from power lines. When installing an outside antenna system, extreme
care should be taken to avoid touching power lines or circuits, as contact with them may be fatal.
Outdoor Antenna Grounding
antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810
of the U.S. National Electrical Code, and Section 54 of the Canadian Electrical Code, provide information with respect to proper ground-
ing of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, loca-
tion of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See the grounding
diagram (right).
Overloading
—Do not overload wall outlets and extension cords, as this could result in fire or electric shock.
Object and Liquid Entry
the openings of these appliances, as they may touch dangerous voltage points
or short-out parts that could result in a fire or electric shock. Care should be
taken so that objects do not fall and liquids are not spilled into the appliance
through openings in the enclosure.
Servicing
—Do not attempt to service these appliances yourself, as open-
ing or removing covers may expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Damage Requiring Service
iced by qualified service personnel when:
• A power supply connection or a plug has been damaged or
• If liquid has been spilled into the appliance or objects have fallen into the
appliance or
• The appliance has been exposed to water or moisture or
• The appliance does not appear to operate normally or exhibits a marked change in performance or
• The appliance has been dropped or the enclosure damaged.
Replacement Parts
ified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, elec-
tric shock, or other hazards. The Master Control Unit battery should be replaced only after turning the power off and only by an author-
ized installer.
Safety Check
—Upon completion of any service or repairs to this audio product, ask the service technician to perform safety
checks to determine that the audio product is in proper operating condition.
Lightning
—For added protection for these audio products during an electrical storm, or when they are left unattended and unused
for long periods of time, turn off the circuit breaker, and disconnect the antenna or cable system. This will prevent damage to the audio
products due to lightning and power-line surges.
Page 2
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
—To reduce the risk of electric shock or fire, these appliances should not be used near water––for exam-
—A.C.Power supply circuits should be routed by a certified electrician only, in accordance with the
—If an outside antenna or cable system is connected to these audio products, be sure the
—Never insert objects of any kind through
—These appliances should be serv-
—When replacement parts are required, be sure the service technician has used replacement parts spec-
E L A N
H O M E
Grounding
Diagram
GROUND
CLAMPS
ELECTRIC
SERVICE
EQUIPMENT
NEC - NATIONAL ELECTRICAL CODE
CEC - CANADIAN ELECTRICAL CODE
©2005 ELAN Home Systems All rights reserved.
S Y S T E M S
ANTENNA
LEAD-IN WIRE
ANTENNA LEAD-IN WIRE
(CEC SECTION 54-200)
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(CEC SECTION 54-200)
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(CEC SECTION 10-700)
(NEC ARTICLE 250, PART H)
Advertisement
Table of Contents
