Reset Function; Other Functions - GE NX-148E Installation And Setup

7n. RESET FUNCTION
The system must be disarmed to perform this function.
ACTION
If the keypad begins beeping, the reset did not execute properly. Enter your code to silence the keypad.
Wait a few minutes and repeat step 2 to attempt another reset.
7o. OTHER FUNCTIONS
(while system is disarmed) Causes the control to do a callback for a download.
control panel. (Refer to the NX Control Panel Installation Manual)
(while system is disarmed) Causes the control to seize the phone line for a download.
control panel. (Refer to the NX Control Panel Installation Manual)
CHIME
(must be enabled in the control panel) Entering
will allow a walk-through zone test where all zones become silent and local (non-
reporting). Each time a zone is faulted, the number of the faulted zone(s) will be
displayed on the keypad and the chime will sound. It will also be entered into alarm
memory and the internal log. To exit at any time during this mode, enter a user code.
Otherwise, the AWalk-Test Mode@ will automatically exit after 15 minutes.
18
A valid user code may be required if feature is enabled in location 41 of the
A valid user code may be required if feature is enabled in location 41 of the
The smoke detectors, zone troubles, and zone
tampers have now been reset.
r
CHIME followed by a user code
RESULT
LCD KEYPAD