Fview Alarm Memory; Test Function; Display Test Function; Ilight Control For X-10 Devices - GE NX-148E Installation And Setup

7f. VIEW ALARM MEMORY
ACTION
or
#
7g. TEST FUNCTION
ACTION
7h. DISPLAY TEST FUNCTION
ACTION
7i. LIGHT CONTROL FOR X-10 DEVICES
When used in conjunction with an X-10 output device such as the NetworX NX-507E, NX-508E, NX-534E
or NX-540E, this menu allows the user to control up to ten X-10 devices from each keypad.
ACTION
[device number]
to turn ON
to turn OFF
#
LCD KEYPAD
Displays the zone descriptions.
Displays the alarm memory list in sequential order
by zone number.
Exits the mode.
Test will be performed as programmed.
If the siren test is performed, enter a user code
to silence the siren.
All display pixels and LED indicators will flash.
Press any key to end test.
Prompts to "Select Light Number 0-9".
Displays the light number on the left.
Prompts to turn the light "On" or "Off" on the right.
Prompts to "Select Light Number 0-9".
Repeat steps 2 and 3 until all devices have been
programmed.
Exits the function.
RESULT
RESULT
RESULT
RESULT
15