View Alarm Memory; Test Function; Reset Function; Set System Date - GE NetworX NX-1600E Series User Manual

VIEW ALARM MEMORY

Step 1 Press
displayed on the keypad.
Step 2 The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed during
the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test, and/or
a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.
Step 1 Press
Step 2 If the siren test is performed, enter a user code to silence the siren.

RESET FUNCTION

This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers.
Step 1 Disarm the system if not disarmed.
Step 2 Press
Step 3 If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps after
repeated attempts, please contact your installer.

SET SYSTEM DATE

Step 1 Press
Step 2 Enter the "Master Code".
Step 3 Enter the "Day of Week "
1 = Sunday
2 = Monday
Step 4 Enter the "Month Code". Must always be two (2) digits.
01 = January
02 = February
03 = March
04 = April
12
r 3
. The zone(s) that created the last alarm will be
r 4
. The test will be performed as programmed.
r 7
. Resets have now been performed.
r 9 6
.
3 = Tuesday
4 = Wednesday
05 = May
06 = June
07 = July
08 = August
5 = Thursday
6 = Friday
09 = September
10 = October
11 = November
12 = December
NX-1600E LCD Keypad
7 = Saturday