Clearances; Assembly; Fitting Rear Rollers - Waldorf RN8510GE Installation And Operation Manual

Clearances

NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Left / Right hand side
Rear
* Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.

Assembly

This model is delivered completely assembled. Ensure legs are securely attached.
NOTE:
 This appliance is fitted with adjustable feet to
enable it to be positioned securely and level on
uneven floors. This should be carried out on
completion of gas connection.
Connection Section'.
 This appliance can also be fitted with rear rollers
to enable appliance to be easily moved for
positioning and cleaning purposes. If desired,
these rollers are supplied in packaging, with
appliance. See below for fitting instructions.
Optional Accessories
(Refer to Replacement Parts List)
 Plinth Kit. For installation details, refer to
instructions supplied with each kit.

Fitting Rear Rollers.

1. Raise appliance from floor by approx. 75mm
using suitable lifting equipment (i.e. Palletiser /
Forklift) to allow rear adjustable feet to be
removed.
2. Unscrew and remove both rear adjustable feet
from rear leg housings.
3. Fit rear roller to rear leg housing and align
screw hole in side of rear leg housing with
threaded hole in rear roller.
4. Secure rear roller to leg support with bolt
supplied and tighten bolt with a 10 mm A/F
spanner.
5. Fit second roller and tighten.
6. Lower appliance back to floor and adjust front
adjustable feet to level appliance.
Combustible Surface
250mm (*)
100mm
Refer to 'Gas
11
Installation
Non Combustible Surface
0mm
0mm
Appliance
Base
Rear Leg
Housing
Adjustable Rear Roller
Foot
Fig 1
Roller
Locating Bolt
Assy