Line Light - Challenge Titan 265 Operator's Manual

11. Close all doors and guards, unlock the main power and switch it on. The machine should
now have power.
12. Press both cut buttons simultaneously to activate the motor and check to make sure it is
turning the same direction as the arrow on the motor casing. If it isn't, disconnect the power
and simply exchange any two leads of the power cord as in Figure 17. The motor will now
turn the correct direction. Double check to make sure.
1

5.9 Line Light

The Titan 265 is equipped with two lights, which provide a line of light on the paper in the
approximate location of where the paper will be cut. The lights come on when power to the machine
is turned on. The light from each bulb reaches the table after passing between the knife and clamp.
Each light is focused with a socket head capscrew see Figure 18
To Adjust:
1. Place a wide sheet of paper on the cut stick to view the line light.
2. Using a 3/16" hex allen wrench, turn one of the cap screws until you see a 1/16-1/8" beam.
NOTE: it is best to start by turning the screw clockwise. If the screw turns all the way in
before a line appears, begin turning the screw counterclockwise.
3. Similarly, turn the adjustment screw of the other bulb, until one continuous beam is seen
across the cut stick.
3 1
2
Figure 17
Line Light
Adj. Screws
Figure 18
5.0 Installation & Setup
2
3
21