Origin-Setting Menu - Roland EGX-350 User Manual

5-5 Description of Menu Items

Origin-setting Menu

 P. 86, "Origin-setting Menu"
XY Origin-setting Menu
Z Origin-setting Menu
Before making these settings, make sure of the following points.
 [AUTO Z CONTROL] must be set to "OFF."
If it is set to "ON, " pressing
disappears and the original menu returns.
 P. 82, "The Position of the Lock Lever," p. 71, "Cutter Installation Method 4"
92
Chapter 5 Feature reference
This makes the setting for the X- and Y-axis origin point. On this machine, this
location is called the "home position. "
 P. 75, "Setting the XY Origin Point (Home Position)"
displays the message shown in the figure below. After three seconds, the message
Z0:
This is the Z-axis origin point during cutting. Set this to match the workpiece
and the cutting data. The lock lever is normally set at position
 P. 62, "Cutter Installation Method 2," p. 71, "Cutter Installation Method 4"
Z1:
This sets the cutting-in depth during cutting as the distance from the Z0 posi-
tion. This means that a change in the Z0 position makes the Z1 position change
as well. Because this cannot be set at a location higher than the Z0 position, the
value of the setting must be negative. If the spindle head is at a higher location
than Z0, the screen displays "" for the Z-axis coordinate.
The lock lever is normally set at position
the computer, the computer's setting takes precedence. Making this setting is
not required.
Z2: This sets the height along the Z axis when performing no-load feed of the cutter
during cutting as the distance from the Z0 position. This means that a change in
the Z0 position makes the Z2 position change as well. Because this cannot be set
at a location lower than the Z0 position, the value of the setting must be positive.
If the spindle head is at a lower location than Z0, the screen displays "" for
the Z-axis coordinate. The lock lever is normally set at position
made the setting on the computer, the computer's setting takes precedence, and
so making this setting is not necessary.
.
. When you've made the setting on
. When you've