Roland EGX-350 User Manual page 70

4-6 Cutter Installation Method 3 (Diamond Scraper)

Wrench
Spindle unit
Wrench
2.
Set the lock lever.
68
Chapter 4 Engraving
Install the solid collet.
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit from
below, then, while holding the spindle unit im-
mobile with a wrench, tighten loosely.
Diameter-4.36 millimeter diamond scrapers can-
not be used with the included solid collet. Provide
a dedicated diamondscraper collet separately.
Solid collet
Fully tighten the solid collet.
Using two wrenches, tighten the solid collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm) .
Wrench
Set the lock lever at the
tion.
For detailed information about the setting posi-
Lock lever
tion for the lock lever, refer to the page indicated
Press down to lower
slightly.
below.
 P. 82, "The Position of the Lock Lever"
or posi-