Roland EGX-350 User Manual page 68

4-5 Cutter Installation Method 2 (No Nose Unit)

Press



This completes the installation of the cutter. Go on to page 75, "Setting the XY Origin Point (Home Position)."
Storage methods for diameter-3.175 mm cutters
When you want to perform repeated use while keeping the amount of extension of the cutter tip constant, then
once you've decided on the amount of extension, we recommend removing the cutter holder and cutter from the
spindle unit without separating them from one another. Storing the assembly without changing the position of
the cutter holder eliminates the need to determine the amount of cutter extension each time with every use.
Note, however, that this method cannot be used with the included diameter-4.36 millimeter solid collet.
Remove the entire cutter-holder assembly
from the spindle unit.
66
Chapter 4 Engraving
.
Use
Press
The Z-axis origin is set.
Press
The main display appears. The coordinate values for Z is set to 0.
and to select [Z0].
to confirm.
.
Store without changing the position
of the cutter holder.