Pausing And Stopping Cutting; Pausing And Resuming Cutting - Roland EGX-350 User Manual

3-6 Pausing and Stopping Cutting

Pausing and Resuming Cutting

This pauses cutting through operation using the handy panel. This enables you to move the cutter to the VIEW position and
check the status of the workpiece, then resume cutting at the location where you paused operation.
Procedure



While cutting is in progress, press
Movement of the cutter pauses. Rotation of the spindle does not stop
at this time.
The display screen shown at left appears.
Use to select "VIEW."
Press to confirm.
Rotation of the spindle stops, and the cutter moves to the VIEW
position.
 P. 45, "Moving to a Specific Position Automatically"
Use or
Press to confirm.
The cutter returns to the location where paused, and cutting resumes.
Selecting "VIEW" or "CONT. " while the front cover is open makes the mes-
sage shown in the figure below appear. After three seconds the message
disappears and the screen returns to the original menu. Close the front
cover, then redo the selection of the operation item.
.
to select "CONT."
Chapter 3 Basic Operation
49