4-7 Cutter Installation Method 4 (End mill)
Wrench
Spindle unit
Wrench
2.
Set the lock lever.
72
Chapter 4 Engraving
Install the collet with the attached
end mill.
Loosely tighten the collet with end
mill.
Insert the collet with end mill into the spindle unit
from below, then, while holding the spindle unit
immobile with a wrench, tighten loosely.
Collet with
end mill
Fully tighten the collet with end
mill.
Using two wrenches, tighten the collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm).
Wrench
Set the lock lever at the
The spindle head is secured in place.
Lock lever
P. 82, "The Position of the Lock Lever"
Lift up.
position.