Roland EGX-350 User Manual page 61

4.
Install the cutter and make the setting for the cutting-in depth.

Workpiece table

If cutter insertion is difficult
If the cutter catches on the solid collet and is difficult
to insert, loosening the cutter holder makes inser-
tion easier. Note that inserting it with undue force
may result in damage to the workpiece. After insert-
ing the cutter, tighten the cutter holder again.
Cutter
Cutter holder
Workpiece table
Loosen the cutter holder.
4-4 Cutter Installation Method 1 (With Nose Unit)
Use ,
to move the spindle head to the area
above the workpiece, then press
to lower the spindle head.
Descent stops automatically when the tip of the
nose unit touches the workpiece table.
 P. 44, "Manual Movement"
Insert the cutter into the cutter holder
and bring the tip of the cutter intcon-
tact with the workpiece table.
When using a diameter-4.36 mm solid
collet
Be careful to orient the cutter correctly.
Cutter
Solid collet
Tab
OK
Chapter 4 Engraving
, , and
Tab
Not OK
59