Related Manuals for Ness D16x C-Bus Enabled
Summary of Contents for Ness D16x C-Bus Enabled
- Page 1 Ness D16x C-Bus™ enabled alarm CoNtrol paNel INstallatIoN & programmINg maNUal For D16x C-BUs optIoNs Revision 1...
-
Page 2: Control Panel Features
• Hex programmable client codes. without a logical device eg. Colour Touch or Pascal logic unit, residing on the network. Ness D16x C-BUs eNaBleD CoNtrol paNel – programmINg maNUal... - Page 3 Clipsal). 4 Wire loom for connection to D16x board. C-BUs WIrINg note that the ness C-Bus interface does not require all the C-Bus wire pairs. C-Bus Positive: blue + orange C-Bus Negative: blue & white + orange & white Remote OFF: brown + brown &...
- Page 4 "C-Bus Failure" message if reconnection fails. FaCtorY DeFaUlt Press p75e 15e to toggle the option on or oFF. oFF (disabled) oFF: C-Bus failure Dialler report is disabled. Notes oN: C-Bus failure Dialler report is enabled. Ness D16x C-BUs eNaBleD CoNtrol paNel – programmINg maNUal...
- Page 5 To program user Code 56 for area1 & area2 arming. Code (user 56), which must be set up in installer program mode, press p56e eXClUDe e 1e e to allow area 1 and/or area 2 arming. Ness D16x C-BUs eNaBleD CoNtrol paNel – programmINg maNUal...
- Page 6 000-255 valUe or action selector depending on the setting of a. seconds or minutes (000-255) or percent (000-100) where relevant. * applications marked with an asterix* do not require a value. Ness D16x C-BUs eNaBleD CoNtrol paNel – programmINg maNUal...
- Page 7 P151e is the PRoGRaMMinG oPTion for output event 1. INstaller's programmINg reCorD output event No. Notes P151e P152e P153e P154e P155e P156e P157e P158e P159e P160e P161e P162e P163e P164e P165e P166e Ness D16x C-BUs eNaBleD CoNtrol paNel – programmINg maNUal...
- Page 8 improvement.
Need help?
Do you have a question about the D16x C-Bus Enabled and is the answer not in the manual?
Questions and answers