Connecting The Power Supply - ELNA eXpressive 900 Instruction Manual

e
r
y
Operating Instructions:
Foot controller Model 21371 is for use with sewing ma-
chine eXpressive 900.
q
w
t

Connecting the Power Supply

First make sure the power switch is off.
Insert the machine plug into the power inlet.
Insert the power supply plug into the wall outlet and turn
the power switch on.
q Power switch
w Machine plug
e Power inlet
NOTES:
Make sure to use the power supply cable that came
with the machine.
If you turn off the power switch, wait for 5 seconds
before turning it on again.
If you wish to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine.
r Foot control cord
t Pin connector
Insert the machine plug of the power supply cable into the
power inlet.
Insert the power supply plug into the wall outlet, and turn
the power switch on.
CAUTION:
Do not pull the foot control cord beyond the red mark.
y Red mark
NOTE:
The foot control cannot be used in the embroidery mode.
WARNING:
When running the machine, always keep your eyes on the
sewing area, and do not touch any moving parts such as
the thread take-up lever, hand wheel or needle.
Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
Operating Instructions:
The symbol "O" on a switch indicates the "off" position of
the switch.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If it does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
6