Customizing Machine Settings Embroidery Mode Settings - ELNA eXpressive 900 Instruction Manual

q
w
e
r
t
y
u-1
u-2
u-3
CUSTOMIZING MACHINE SETTINGS
Embroidery mode settings
Press the embroidery setting mode key (refer to page 86).
q Auto thread tension
The auto thread tension level can be adjusted with
the "+" or "–" key. Increase the value when using the same
threads on the bobbin and needle.
w Low bobbin thread warning
The low bobbin thread warning level can be adjusted with
the "+" or "–" key. To turn this option off, press the "–" key
until "OFF" shows in the window.
e One stitch stop on/off
When this function is turned on, the machine sews one
stitch and stops automatically so that you can bring the
bobbin thread up before sewing.
Press the next page key to go to the next menu.
r Embroidery foot height
The machine measures fabric thickness and automatically
sets the presser foot to the optimum height.
However, you can fine tune the foot height according to
fabric material and/or other sewing conditions by pressing
the "+" or "–" key. The adjustable range is 0 mm to 4 mm.
t Consecutive color grouping on/off
If an imported stitch data file or design files of a pattern
combination contain consecutive sections in the same
color, these sections are automatically grouped together
as one section when opening the file or saving the pattern
combination as the file or going to the ready to sew
window. This function is invalid when combining the built-
in designs and external sourced designs.
Turn this option off if you do not wish to group the
sections together.
Press the next page key to go to the next menu.
u
y Auto thread cutting (basic)
The machine automatically trims the threads when it
stops to change the thread to the next color when this
option is turned on.
u Auto thread cutting (advanced)
Press the customize key
setting window.
u-1 Jump thread cutting length
You can set the cutting length of jump threads by pressing
the "+" or "–" key. The adjustable range is 3 mm to 30 mm
and "OFF".
You need to set the cutting length to "OFF" if you turn on
the cutting command option.
u-2 Thread cutting at color change and end of
sewing on/off
The machine automatically trims the threads at the end of
sewing and when it stops to change the thread to the next
color if this option is turned on.
u-3 Cutting command on/off
If an imported embroidery stitch data file contains a trim
code (cutting command), turn this option on to trim the
threads at the trim code.
Press the next page key to go to the next menu.
126
to open the advanced