Tail Light Assembly - Skoda Citigo Owner's Manual

Tail light assembly

Fig. 124 Removing the tail light assembly
Fig. 125 Tail light assembly: Replacing bulbs
ä
First read and observe the introductory information and safety warn-
ings on page 141.
Fold the seat rest of the rear set bench forward to make it easier to reach the
cover of the rear light more easily » page
wards.
Removing and installing the tail light
›
Open the luggage compartment door and unscrew the luggage compartment
cover » page 45.
›
Prise the cover » Fig. 124, insert the screwdriver underneath the lower edge
1
of the locking mechanism » page
3
mechanism at the connector in the direction of arrow.
2
›
Press the locking mechanism
4
144
Do-it-yourself
42, Folding the rear seat backrest for-
127, Vehicle tool kit and pull the locking
and remove the connector .
2
›
Hold the tail light assembly in the installation position with one hand, and re-
move the plastic nut with the other.
5
›
Carefully remove the tail light from the body and place it on a clean, smooth
surface.
›
Unlock the lamp holder on the locking latches (arrows)
move the bulb holder from the tail light.
›
To reinsert the bulb holder, first place the bulb housing in the tail light assem-
bly. All locking plates (arrows) must audibly snap into place.
›
Carefully place the tail light assembly in the opening in the body.
›
Hold the tail light assembly with one hand, and attach and tighten the plastic
nuts with the other hand.
5
›
Insert the connector on the lamp holder and press the locking mechanism
2
towards the tail light.
›
Fold the cover back, install the luggage compartment cover, and close the
1
luggage compartment cover.
Fold the rear seat backrest back.
Replacing the bulbs in the tail light assembly
›
Push the faulty bulb into the holder, turn in an anti-clockwise direction up to
the stop and remove » Fig. 125 - .
›
Insert a new bulb into the socket and turn in a clockwise direction to the the
stop.
» Fig. 125 -  and re-
