›
Let all of the occupants get out. While changing a tyre, the occupants of the
vehicle should not stand on the road (instead they should remain behind a crash
barrier).
›
Switch off the engine and move the gearshift lever into Neutral or move the
selector lever for the automatic gearbox into position N.
›
Firmly apply the handbrake.
›
Remove the vehicle tool kit and the spare wheel from the luggage compart-
ment
» Fig.
107.
Changing a wheel
ä
First read and observe the introductory information and safety warn-
ings
on page 128.
Always change a wheel on a level surface as far as possible.
›
Remove the full wheel trim
» page 123
›
First of all slacken the anti-theft wheel bolt and then the other wheel
bolts
» page
130.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground
» page
131.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper, etc.).
›
Remove the wheel.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Alternately tighten the wheel bolts opposite each other using the wheel
wrench (crosswise) and then tighten the anti-theft wheel bolt
›
Install the full wheel trim/wheel trim cap or the caps.
Note
All bolts must be clean and must turn easily.
■
Under no circumstances grease or oil the wheel bolts!
■
When fitting unidirectional tyres, ensure that the direction of rotation is cor-
■
rect
» page
122.
Subsequent steps
ä
First read and observe the introductory information and safety warn-
ings
on page 128.
The following steps must also be performed after changing the wheel:
or caps
» page
123.
» page
130.
›
Stow and attach the replaced wheel in the spare wheel well using a special
screw.
›
Stow the vehicle tool kit in the space provided.
›
Check the tyre pressure on the installed spare wheel as soon as possible.
›
Have the tightening torque of the wheel bolts checked with a torque wrench
as soon as possible.
›
Change the damaged wheel or consult a specialist garage about repair possibil-
ities.
Note
If it is determined that the wheel bolts are corroded and difficult to turn when
■
changing the wheel, the bolts must be replaced before checking the tightening
torque.
Drive cautiously and only at a moderate speed until the tightening torque has
■
been checked.
129
Do-it-yourself