Skoda Citigo Owner's Manual page 70

WARNING (Continued)
The City Safe Drive system cannot detect persons, animals, or crossing vehi-
■
cles or approaching vehicles in the same lane.
The City Safe Drive system cannot exceed physical and system-defined lim-
■
its. For instance, responses from the City Save Drive system can happen late
or unexpectedly from the driver's perspective. Always stay attentive and take
control when required.
CAUTION
If the vehicle starts to roll after the City Safe Drive system is triggered, use the
foot pedal to break.
Note
When replacing the windscreen wiper blades, only use windscreen blades ap-
■
proved by ŠKODA.
Do not paint the laser sensor range on the windscreen. Do not cover it up with
■
stickers or similar.
Remove any snow with a hand-held brush and we recommend you remove any
■
ice with a solvent-free deicing spray.
Keep the laser sensor range free of dirt and ice at all times.
■
If the laser sensor range on the windscreen has scratches, cracks, etc, replace
■
the windscreen. Only use windshields approved by ŠKODA. Carrying out repairs to
the windscreen are not permissible.
A damaged windscreen in the area of the laser sensor can lead to a failure of
■
the City Safe Drive system.
Repairing the laser sensor requires specialist expertise. We recommend an au-
■
thorised ŠKODA Service partner.
Switching the City Safe Drive on and off
ä
First read and observe the introductory information and safety warn-
ings on page 68.
Switching on the City Safe Drive
The City Safe Drive system is automatically switched on after turning on the igni-
tion.
Switching the City Safe Drive system on and off again
The City Safe Drive system is switched off by pressing the button
front centre console.
When the City Safe Drive system is switched off while the vehicle is travelling at a
speed between 5 – 30 km/h (3 - 19 mph), the warning light   will light up in
the instrument cluster display.
You can switch on the City Safe Drive system again with the button
warning light   lights up for around 5 seconds in the instrument cluster dis-
play.

The City Safe Drive system must be switched off in the following cases.
›
When the vehicle is being towed away.
›
When the vehicle is driven though an automatic car wash.
›
When the vehicle is on a rolling test bench.
›
When the laser sensor is faulty.
›
After force is applied to the laser sensor.
›
When driving off-road (overhanging branches).
›
When objects are extending into the area above the bonnet, e.g. when a rood
load sticks out far ahead.
›
When the windscreen is damaged in the region of the laser sensor.
Fig. 69
Lower part of the centre con-
sole: Button for the City Safe
Drive system
» Fig. 69 in the
» Fig. 69. The
69
Starting-off and Driving
