WARNING
A discharged vehicle battery may already freeze at temperatures just below
■
0 °C. In case of frozen battery carry out no jump-starting - risk of explosion!
Pay attention to the warning instructions relating to working in the engine
■
compartment
» page
109.
The non-insulated parts of the terminal clamps must never make contact
■
with each other. In addition, the jump-start cable connected to the positive
terminal of the battery must not come into contact with electrically conduct-
ing parts of the vehicle - risk of short circuit!
Do not clamp the jump-start cable to the negative terminal of the dis-
■
charged battery. There is the risk of detonating gas seeping out the battery
being ignited by the strong spark which results from the engine being started.
Route the jump-start cables so that they cannot be caught by any rotating
■
parts in the engine compartment.
Do not bend over the battery - risk of caustic burns!
■
The vent screws of the battery cells must be tightened firmly.
■
Keep any sources of ignition (naked flame, smouldering cigarettes, etc.)
■
away from the battery - risk of an explosion!
Never jump-start vehicle batteries with an electrolyte level that is too low -
■
risk of explosion and caustic burns.
Note
There must not be any contact between the two vehicles otherwise current
■
may flow as soon as the negative terminals are connected.
The discharged battery must be properly connected to the system of the vehi-
■
cle.
We recommend you buy jump-start cables from a car battery specialist.
■
Jump-starting
ä
First read and observe the introductory information and safety warn-
ings
on page 134.
The jump-start cables must be attached in the following sequence.
Connecting positive terminals
›
Attach one end
» Fig. 114
1
.
A
›
Attach the other end
to the positive terminal of the battery supplying the
2
power
.
B
Connecting negative terminal and engine block
›
Attach one end
» Fig. 114
3
the power
.
B
›
Attach the other end
to a solid metal part which is connected firmly to the
4
engine block, or to the engine block itself.
Starting engine
›
Start the engine on the vehicle providing the power and allow it to idle.
›
Now start the engine of the vehicle with the discharged battery.
›
If the engine does not start, terminate the attempt to start the engine after
10 seconds and wait for about 30 seconds before repeating the process.
›
Disconnect the cables in exactly the reverse order to the one described above.
Fig. 114
Jump-starting using the battery
from another vehicle: A - flat ve-
hicle battery, B - battery provid-
ing current
to the positive terminal of the discharged battery
to the negative terminal of the battery supplying
Do-it-yourself
135