Skoda Citigo Owner's Manual page 67

Note
It is not possible on vehicles fitted with an automatic gearbox to switch on the
cruise control system if the selector lever is in the position N or R.
Storing a speed
ä
First read and observe the introductory information and safety warn-
ings on page 65.
Storing a speed
›
Turn the switch » Fig. 66 into the ON position.
A
›
After the desired speed has been reached, press the rocker button
SET position.
After you have released the rocker button
you have just stored is maintained at a constant speed without having to depress
the accelerator.
Changing a stored speed
ä
First read and observe the introductory information and safety warn-
ings on page 65.
Increasing the speed with the accelerator
›
Depress the accelerator to increase the speed.
›
Release the accelerator to reduce the speed back down to the preset speed.
However, if the saved speed is exceeded by more than 10 km/h for a period of
more than 5 minutes by depressing the accelerator, the stored speed is deleted
from the memory. You have to re-store the desired speed.
66
Using the system
Fig. 66
Turn signal and main beam lever:
Rocker switch and switch of the
cruise control system
into the
B
out of the position SET, the speed
B
Increasing the speed with the rocker button
›
Press the rocker button » Fig. 66
B
›
The speed will increase continuously, if the rocker button is pressed and held in
the RES position. Release the rocker button once the desired speed is reached.

The set speed is then stored in the memory.
Decreasing the speed
›
The stored speed can be reduced by pressing the rocker button
into the position SET.
›
The speed will decrease continuously, if the rocker button is pressed and held
in the SET position. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
›
If the rocker button is released at a speed of less than 30 km/h, the speed is
not stored and the memory is erased. The speed must then be stored again by
pressing the rocker button
B
the vehicle to more than 30 km/h.
The speed can also be reduced by depressing the brake pedal, which temporarily
deactivates the system.
Switching off the cruise control system temporarily
ä
First read and observe the introductory information and safety warn-
ings on page 65.
The cruise control system is temporarily switched off by pressing the switch
» Fig. 66 into the spring-tensioned position CANCEL or by depressing the
A
brake or clutch pedal.
The set speed remains stored in the memory.

Briefly press the rocker button
speed after the clutch or brake pedal is released.
Switching off the cruise control system completely
ä
First read and observe the introductory information and safety warn-
ings on page 65.
›
Turn the switch » Fig. 66
A
B
into the RES position.
in the position SET after increasing the speed of
into the position RES to resume the stored
B
into the OFF position.
» Fig. 66
B


