Skoda Citigo Owner's Manual page 20

Hide thumbs Also See for Citigo:
Table of Contents

Advertisement

CAUTION
The red oil pressure light
is not an oil level indicator! One should therefore
check the oil level at regular intervals, preferably after every refuelling stop.
EPC
fault light

The
(Electronic Power Control) warning light comes on for a few seconds when

the ignition is switched on.
If the warning light
does not go out after starting the engine or it lights up

when driving, there is a fault in the engine control system. The engine manage-
ment system selects an emergency programme which enables you to drive to the
nearest specialist garage by adopting a gentle style of driving.
Coolant temperature/coolant level
The warning light
comes on for a few seconds when the ignition is switched
on.
The coolant temperature is too high or the coolant level too low if the warning
light
does not go out or flashes while driving.
An audible signal sounds as a warning tone.
In this case, switch off the engine, check the coolant level and top up the cool-
ant, if necessary.
Do not continue your journey if for some reason it is not possible to top up the
coolant under the prevailing conditions. Serious engine damage is possible.
Therefore, switch the engine off and seek help from a specialist garage.
If the coolant is within the specified range, the increased temperature may be
caused by an operating problem at the radiator fan. Check the fuse for the radia-
tor fan, replace if necessary
» page
Do not continue driving if the warning light does not go off even though the
coolant level is correct and the fuse for the fan is in working order. Seek help from
a specialist garage.
Further information
» page
112, Coolant.
140, Fuses in the engine compartment.
WARNING
If you have to stop for technical reasons, then park the vehicle at a safe dis-
tance from the traffic, switch off the engine and activate the hazard warning
light system
» page
34.
Stabilisation control (ESC)
The warning light
comes on for a few seconds when the ignition is switched
on.
When the ESC helps to stabilise the vehicle, the warning light
strument cluster.
The indicator light illuminates permanently if there is a fault in the ESC .
As the ESC operates in conjunction with the ABS, the ESP indicator light will also
come on if the ABS system fails.
If the indicator light
comes on immediately after starting the engine, the ESC
can be switched off for technical reasons. In this case, the ESC can be switched
on again by switching the ignition on and off. If the indicator light goes out, the
ESC is fully functional again.
Further information
» page
62, Stabilisation control (ESC).
Note
If the vehicle's battery has been disconnected and reconnected, the warning light
comes on after switching on the ignition. The warning light should go out after
driving a short distance.
Traction Control System (TCS)
The warning light
comes on for a few seconds when the ignition is switched
on.
The warning light comes on when driving when a control cycle is activated.
The indicator light illuminates permanently if there is a fault in the TCS.
The fact that the TCS operates together with the ABS means that the TCS warn-
ing light will also come on if the ABS system is not operating properly.
flashes in the in-
Instruments and warning lights
£
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents