›
Remove the connector.
›
Turn the bulb holder
» Fig. 179
A
and remove.
›
Insert the bulb holder with the new buln into the headlight and turn in a clock-
wise direction as far as the stop.
›
Fit the connector.
›
Replace the fog lamp by inserting it in the opposite direction of the arrow
» Fig. 178
and tighten.
3
›
Insert the protective grille and carefully press it in.
The protective grille must engage firmly.
Changing the bulb for the licence plate light
Fig. 180 Remove the number plate light/replace the bulb
First read and observe the introductory information and safety warn-
ings
on page 202.
›
Open the luggage compartment lid.
›
Insert a slotted screwdriver at the location indicated by the arrow
press it in lightly, and unlatch the springs.
›
Remove the lamp.
›
Pull the faulty bulb out of the holder in the direction of the arrow
›
Insert a new bulb into the holder.
›
Replace the lamp and lightly press it until the spring latches.
in an anti-clockwise direction up to the stop
» Fig. 180
» Fig. 180
Tail lamp assembly
Fig. 181 Remove cover/light
Fig. 182 Installing the lamp connector/lamp
First read and observe the introductory information and safety warn-
ings
on page 202.
- ,
Removing
›
Open the luggage compartment lid.
›
Insert the clamp for removing the wheel trims into the hole at the position
- .
indicated by the arrow
» page
›
Remove the cover in the direction of the arrow
›
Use the screwdriver from the tool kit
›
Grip the tail lamp assembly and carefully remove it by pulling vertically to the di-
rection of travel with loosening movements.
›
Press together the interlocks on the connector in the direction of the arrow
» Fig. 182
- .
1
188, Vehicle tool kit -
» Fig.
181.
» Fig. 181
- .
» Fig. 181
- to unscrew the lamp.
Fuses and light bulbs
205