74
Error, Genlock Sync Lost.
Sense Key
Additional Sense Code and Qualifier
Additional Sense Bytes 18 & 19
The decoder from that point on will remain in Standalone mode until genlock
mode is re-enabled by the host.
The genlock hardware requires a genlock resync, which results in a momentary
picture glitch, jump, or white flash when genlock mode is first enabled. The
genlock resync will occur 3–4 seconds after one of the following conditions:
1. The first time the decoder is put into genlock mode (via the Genlock
command 0x0016).
2. When genlock is enabled and the video standard is changed, i.e., when
changing between NTSC and PAL.
3. After a loss of genlock. The genlock resync will occur upon reacquisi-
tion and detection of the genlock signal.
Genlock Source Selection: The CineCast Quad Pro allows each decoder chan-
nel's genlock source to come from one of three possible sources. This gives the
ability to lock one, two or four channels together to a genlock source.
Bit 11–10
00b
01b
10b
11b
When channel pairs (0 and 1 or 2 and 3) are configured for audio/video switched
playback, both channels must be genlocked together.
• LUN 0 & 1 with genlock input on LUN 0 (Channel 1):
Channel 1 LUN 0 in mode 00b
Channel 2 LUN 1 in mode 10b
DECODER Command (45h)
CineCast Quad Pro Version 2.6 Installation and User Manual
SCSI Status
Decoder's own genlock input (default)
Channel 1 (LUN 0) genlock input
Adjacent Channel genlock input
Reserved
Check Condition
01h
6100h
0107h
Genlock