Table of Contents
Advertisement
22
return to this screen to install the SDK at a later time if you need to).
• Reminder: If you have not already done so, you must enable "MFC Update"
and "CineCast Decoder Application." These two checkboxes must be
checked when requesting the SDK to insure proper installation of the SDK.
• Click Next to proceed with the installation.
• On the "Select Program Manager Group" screen (Figure 1-6), accept Vela
Research by clicking Next.
• On the "Start Installation" screen (Figure 1-7), click Next.
• A "DO NOT REMOVE THE CD" message box will display as a reminder
that a number of reboots may be required during the installation process.
Click OK to continue.
• If you have chosen to run the MFC Update option, the installation process
will begin here to copy files.
• On the "Install" message box (Figure 1-8), note that the system must
be restarted. Click OK, and then wait as the system reboots. Leave the
CD-ROM in the drive through the system restart process.
10. If you remembered to leave the CD-ROM in the drive, the setup application
will appear soon after the reboot. Continue the installation by following these steps:
• On the "CineCast License Agreement" screen (Figure 1-9), select the "I
Agree" radio button after reading the agreement. Then click OK. The
application will install some files.
11. If you elected to install the SDK:
• Select the "I Agree" radio button on the "CineCast SDK End User
License Agreement" screen (Figure 1-10). Click OK.
• On the Password screen (Figure 1-11), you will be asked for a password. Use
the one supplied when you purchased your Software Developer's Kit. If you
have problems finding your password, contact Vela Support. After entering
the password, click OK. A few more files will be installed.
12. On the "Installation Complete" screen (Figure 1-12), note that CineCast 2.6
has been successfully installed. Click Finish.
13. The "Install" message box (Figure 1-8) will note that the system must be re-
started. Click OK, then let the system reboot. Leave the CD-ROM in the drive.
14. After the system has been rebooted, close the setup application if it is active,
then remove the CD-ROM disc from the drive.
Software Installation
CineCast Quad Pro Version 2.6 Installation and User Manual
Advertisement
Table of Contents
