Table of Contents
Advertisement
70
• Set Trigger Playback on specific Input LTC time code:
1. Send "Set Time Code" (command 0004h) with trigger time code.
2. Send "MPEG Play" with fields "Trigger"=1 and "Trigger
Mode"=010b (Trigger on LTC input match).
• Modify Start Time:
Allows the Playback start time to be modified when using Play on Input
LTC time code. When a Play on Input LTC time code trigger is queued or
pending, the start time can be modified by sending this commend with
byte 4 bit 1 set.
• Execute an Inline trick mode (e.g., Pause or Stop) at a specific time code:
1. Send "Set Time Code" (command 0004h) with specific time code.
2. Send decoder command (such as Stop or Pause) with fields "Inline" =
1 and "Inline Mode" = 011b.
0005 LTC/VITC Timecode Configuration: This command configures the LTC
output.
Command Bits
Bit 8
LTC Enable
Bit 9
VITC Enable
Bits 11–10
Output Time
Code Source
Bits 15–12
Reserved
0008 Set Audio Gain: Each audio output has an adjustable gain control from
+12dB to -84dB. The host must pass a gain value in dB. The parameter passed to
the firmware is the gain in dB times 16, giving a resolution of 1/16 dB. The host
passes a 12-bit signed (two's complement) value of the gain for both the primary
and secondary outputs. 32-bits of data are used to pass the gain parameter.
• Byte 4 & 5 — Primary Audio Gain
• Byte 6 & 7 — Secondary Audio Gain
DECODER Command (45h)
CineCast Quad Pro Version 2.6 Installation and User Manual
Function Name
Reserved (LTC output always enabled).
Reserved (VITC not supported).
00b = Use GOP header SMPTE time code (default)
01b = Use user-defined starting time code. See com-
mand 0004h, "Set Time Code."
10b, 11b = Reserved
Reserved
Comments
Advertisement
Table of Contents
