Table of Contents
Advertisement
36
Components. These two check-boxes must always be checked when request-
ing the SDK — This insures proper installation of the SDK.
• On the "Install" message box (Figure 1-8), note that the system must be
restarted. Click OK, and then wait as the system reboots. Leave the CD-
ROM in the drive through the system restart process.
5. If you remembered to leave the CD-ROM in the drive, the setup application
pops up immediately after the reboot. Continue with the installation by following
these steps:
• On the "CineCast End User License Agreement" screen (Figure 1-9), select
the "I Agree" radio button after reading the agreement. Then click OK. The
application will install some files.
6. If you elected to install the SDK:
• Select the "I Agree" radio button on the "CineCast SDK End User License
Agreement" screen (Figure 1-10). Click OK.
• On the Password screen (Figure 1-11), you will be asked for a password. Use
the one supplied when you purchased your Software Developer's Kit. If you
have problems finding your password, contact Vela Support. After entering
the password, click OK. A few more files will be installed.
7. On the "Installation Complete" screen (Figure 1-12), note that CineCast 2.6
has been successfully installed. Click Finish.
8. The "Install" message box (Figure 1-8) will note that the system must be re-
started. Click OK, then let the system reboot. Leave the CD-ROM in the drive.
9. After the system has been rebooted, close the setup application if it is active,
then remove the CD-ROM from the drive.
Software Installation
CineCast Quad Pro Version 2.6 Installation and User Manual
Advertisement
Table of Contents
