Table of Contents
Advertisement
66
Inline
Mode
0000b
MPEG Data Mode (default): Command will remain pending until the cur-
rent MPEG data block has been sent to the MPEG decode hardware.
When an "inline" command is received, it is referenced to the last 64-K
block of MPEG data loaded into the MPEG buffer. The command will
remain pending until the MPEG data from that block has been loaded into
the MPEG decode hardware.
0001b
Output SMPTE Time Code Mode: Command will remain pending until a
specific output time code (either MPEG GOP time code or extracted VITC
time code) is reached. Use command 0004 Set Time Code to set the spe-
cific time code.
0010b
Input LTC Time Code Mode: Command will remain pending until a spe-
cific Input LTC time code occurs Use command 0004 Set Time Code to
set the specific time code.
0011b
Frame Count Mode: Command will remain pending until a specific frame
count is reached. Use command 0024 Set Frame Count to set the specific
frame count.
0100b
Playback Start: Command will remain pending until MPEG play has
started.
0101b
Playback End: Command will remain pending until MPEG play has
stopped.
0110b
GPIN1 Active: Command will remain pending until GPIN1 is activated
(grounded).
0111b
GPIN1 Inactive: Command will remain pending until GPIN1 is deacti-
vated (open).
1000b
GPIN2 Active: Command will remain pending until GPIN2 is activated
(grounded).
1001b
GPIN2 Inactive: Command will remain pending until GPIN2 is deacti-
vated (open).
1010b
Adjacent Channel Output SMPTE Time Code mode: Command will remain
pending until a specific output time code of the adjacent channel is
reached. Use command 0004 Set Time Code to set the specific time code.
DECODER Command (45h)
CineCast Quad Pro Version 2.6 Installation and User Manual
Inline Event Triggering Command Execution
Advertisement
Table of Contents
