Check Engine Oil And Recharge; Transmission Lubrication - Joyner JNSZ650DL Owner's Manual

Hide thumbs Also See for JNSZ650DL:
Table of Contents

Advertisement

Figure 19
With the engine warm, put the vehicle on the level ground.
a. Shut down the engine; put a collecting oil plate under the engine oil outlet.
Loosen the oil outlet plug in the warm engine. Let the engine oil out fully (see
Figure 17).
b. Tighten the engine oil outlet plug.
c. Remove the oil filler cap (see Figure 16), fill oil (SAE 10W/10~50) about 2.8
liters to the engine.
d. Pull out the engine oil dip stick (see Figure 16), confirm the corrective oil
level in the crankcase (see Figure 19).

Check engine oil and recharge

a. If the color of engine oil changes, you need to replace the engine oil.
Replace the engine oil as above.
b. Check the engine oil level, change if necessary from d as above.

Transmission lubrication

You must change the oil in the transmission after the first 5 hours of operating
of your new engine and after 10 hours of use thereafter. That will insure proper
lubrication of internal parts and prevent costly repairs due to excessive wear.
Figure 21
a. Put the vehicle on the level ground.
b. Shut down the engine, put a collecting oil plate under the transmission oil
outlet. Loosen the oil outlet plug in the warm engine. Let the transmission oil
out fully (see Figure 20).
c. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by
moving parts will stick to the plug. Clean the iron dust from this dust plug.
d. Tighten the transmission oil outlet plug and the iron dust plug.
Figure 18
Figure 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents